Solenoid valves are available as 2-Way, 3-Way, and 4-Way. The application will dictate the types of solenoid valves you chose.
Model |
4V110-M5 |
4V120-M5 |
4V130C-M5 |
4V130E-M5 |
4V130P-M5 |
4A110-M5 |
4A120-M5 |
4A130C-M5 |
4A130E-M5 |
4A130P-M5 |
|
Position and way No. |
Two-position Five Way |
Three-position Five Way |
|||
Effective sectional area |
10mm²(CV=0.56) |
7mm²(CV=0.10) |
|||
Position No. |
Two-position Three-way |
||||
Effective section area |
10mm²(CV=0.56) |
||||
Port size |
Air inlet+Air Outlet+Exhaust=M5x0.8” |
||||
Working Medium |
Air (40Micron Filtered) |
||||
Action type |
Inner Guide Type |
||||
Working Pressure |
0.15~0.8Mpa |
||||
Voltage Range |
±10% |
||||
Power Consumption |
AC:5VA DC:2.8W |
||||
Insulation&protection Class |
F Class. IP 65 |
||||
Wiring Form |
Lead wire or connector type |
||||
Max.Frequency |
5 times/Sec |
||||
Shortest Activate Time |
0.05 Second |
||||
Max pressure Resistance |
1.2Mpa |
All materials used in the construction of the valves are carefully selected according to the varying types of applications. Body material, seal material, and solenoid material are chosen to optimize functional reliability, fluid compatibility, service life and cost.
Neutral fluid valve bodies are made of brass and bronze. For fluids with high temperatures, e.g., steam, corrosion-resistant steel is available. In addition, polyamide material s used for economic reasons in various plastic valves.
All parts of the solenoid actuator which come into contact with the fluid are made of austenitic corrosion-resistant steel. In this way, resistance is guaranteed against corrosive attack by neutral or mildly aggressive media.
The particular mechanical, thermal and chemical conditions in an application factors in the selection of the seal material. the standard material for neutral fluids at temperatures up to 194°F is normally FKM. For higher temperatures EPDM and PTFE are employed. The PTFE material is universally resistant to practically all fluids of technical interest.
Pressure Ratings – Pressure Range:
All pressure figures quoted in this section represent gauge pressures. Pressure ratings are quoted in PSI. The valves function reliably within the given pressure ranges. Our figures apply for the range 15% undervoltage to 10% overvoltage. If 3/2-way valves are used in a different operation, the permitted pressure range changes. Further details are contained in our data sheets.
In the case of vacuum operation, care has to be taken to ensure that the vacuum is on the outlet side (A or B) while the higher pressure, i.e. atmospheric pressure, is connected to the inlet port P.
The flow rate through a valve is determined by the nature of the design and by the type of flow. The size of valve required for a particular application is generally established by the Cv rating. This figure is evolved for standardized units and conditions, i.e. flowrate in GPM and using water at a temperature of between 40°F and 86°F at a pressure drop of 1 PSI. Cv ratings for each valve are quoted. A standardized system of flowrate values is also used for pneumatics. In this case the air flow in SCFM upstream and a pressure drop of 15 PSI at a temperature of 68°F.
MOQ:100PCS
Lead Time: in 7 days
Delivery: by express/by sea/by air
Payment Terms: By T/T