Microduct Connectors

Micro Duct Accessories system with high quality is very important to Pipe Network construction and cable blowing.

• Micro duct joint accessories provided by micro pipeline system.

• Can endure the blowing pressure of not less than 16bar and owns gas sealing performance, and reliable, speedy joint properties.

• The joint accessories are designed to be translucent, which can visually observe if the connection is put in place or not and blowing status.

● Resistant to high pressures for blowing micro cables through guide tubes

● Resistant to corrosion and most chemicals

● Water and air tight

● Suitable for use in a wide range of working temperatures

End caps are airtight caps used to keep debris out of the end of the micro duct when pulling duct through existing conduit and plowed holes, sealing the end of the conduit temporarily. The end cap is a clear cap that installs much like the couplers providing an airtight seal.

DESCRIPTION:

Standard transparent end caps, which are used to terminate open ended Tubes to avoid air leakage, water or other material ingress.End caps are preassembled with security clips.

MAIN FEATURES:

① Safety clips included

②  Push-ft technology

③  Working Pressure: max. 25 bars

DESCRIPTION：

Reducing connectors allows interconnection between two micro-ducts with different outer diameter. Typically this is the case of transition point from DB to DI micro-duct entering the house. If you have not fnd your correct size among METAL FREE or REINFORCED than choose one of these.

MAIN FEATURES：

① Safety clips included

②  Push-ft technology

③  Working Pressure: max. 25 bars

DESCRIPTION:

Microduct Straight connectors, which guarantee a good performance. Transparent body allows verification of the micro-ducts position inside. Safety clips,tamper evident, are pre-installed. Tested & comply with EN 50411-2-8.

MAIN FEATURES:

① Safety clips included

②  Push-ft technology

③  Working Pressure: max. 25 bars

Euroland Company have all of your MicroAccessories needed for any installation with MicroDucts. Our product line of MicroAccessories includes connectors,end caps and gas block, connectors with clip.

Available separetely, or pre assembled onto your choice of fitting, Euroland Company supply an extensive range of customised polypropylene snap lock covers.Direct buried covers are available for straight reducers and end stop microduct connectors.

Direct buried covers prevent the accidental release of collets during installation by utilising moulded-in tabs. Further security is afforded by a positive snap to lock tab.

By specifying Euroland direct buried covers,microduct connector fittings are protected from both impact and crushing forces and can be retrospectively fitted to network installations prior to infill.

DESCRIPTION:

Simple modular design enables easy installation in all situations, even if cable is already terminated.

Made of glass-fiber reinforced polyamide, provides gas-tight sealing of your micro-duct with cable up to 0,5 bar. Very compact design helps to installations in congested spaces like inside ODF.